Valor DV-190 Owner's Manual download pdf (Page 16)

Remote Control Preparation

CAUTION! Do not connect the batteries to the remote control receiver until the wires are

connected to the burner control unit, as short circuit could result in destruction of the

electrical components.

Connect the wiring harness to the receiver box by pushing the wire connector on to the receiver circuit

board. The plug will only go on one way so please ensure that the wires are pointing up and the slot in

the board is in line with the tab on the wiring harness plug.

Connect the wires “A” (with the “L” terminals) to the connectors “B” on the control valve. Please note that

the connectors are different sizes; the smaller one ﬁ ts to the lower connection on the valve.

Connect the wires “C” to the connectors “D” on the control valve. (Either wire can be ﬁ tted to either

connector.)

Remove the remote control receiver lid.

Fit four 1.5 V batteries. Reﬁ t the lid.

Place the remote control receiver of the Velcro pad.

Fit the 9 V battery to the handset transmitter.

Remote control receiver

Receiver Cable

LED (green)

Sensor Opening

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

No comments

Valor DV-190 Owner's Manual Page 16