Valor DV-190 Owner's Manual download pdf (Page 17)

Ceramic Logs Installation (739IL)

Unpack the ceramic logs very carefully to avoid damaging the fragile material. Install the logs as shown below. Please

note that the position of the logs is critical to ensure proper performance of the appliance.

1. Spread the decorative charcoals on

each side of the log tray, covering the

sheet metal as shown.

DO NOT PUT ANY DECORATIVE

CHARCOAL PIECES WITHIN THE

PILOT SHIELD AREA.

2. Place the rear log centering it side to side in the

ﬁ rebox. Position forward until it sits against the sheet

metal return behind the burner.

3. Place the front left log on top of the burner with its

front edge resting slightly on the window frame.

4. Place the front right log on the top of the burner with

its left end abutted to the front left log and its front

edge resting slightly on the window frame.

Both front logs to rest slightly on the

edge of the ﬁ rebox window frame.

Center the front logs side to

side in relation to the ﬁ rebox

5. Identify the right cross log; it has

a hole under on of its end and it is

the shortest cross log. Place it on

the right pin located on the rear log.

Rest its other end in the crook of the

front right log.

6. Identify the middle cross log. It does not have a

hole underneath. Place its narrow end on the ﬂ at

depression in the rear log next to the right cross log

on the rear log. Place its wider end on the front log.

7. Identify the left cross log; it has a hole under its

narrow end. Place its narrow end on the pin located

on the rear log. Rest its wider

end on the the crook in the

front left log at an angle of

approximately 30 degrees

from the center line of the

ﬁ replace to allow for the

ﬂ ame to come up in front of

the rear log.

Rear Log

against

Sheet Metal

Return

INSTALLATION

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comments to this Manuals

No comments

Valor DV-190 Owner's Manual Page 17

Comments to this Manuals